Installing The Aspen 8810 Spare Fan Tray - Extreme Networks BlackDiamond 8810 Hardware Installation Manual

Installing the Aspen 8810 Spare Fan Tray

Follow these steps to ensure proper installation of the Aspen 8810 spare fan tray into the Aspen chassis:
1 Ensure that the fan tray slot on the chassis is empty.
2 Attach the ESD-preventive wrist strap, that is provided, to your wrist and connect the metal end of
the ESD-preventive wrist strap to the ground receptacle that is located on the top-left corner of the
chassis.
3 Align the spare fan tray with the fan tray slot on the chassis.
4 Lift the spare fan tray into the fan tray slot on the chassis by placing one hand on the fan tray handle
and the other hand guiding the bottom of the spare fan tray.
CAUTION
Ensure that both hands are used to support the weight of the fan tray.
5 Gently slide the spare fan tray into the fan tray slot on the chassis using the fan tray handle as
shown in Figure 80.
Figure 80: Installing the fan tray into the tray slot on the Aspen chassis
6 Turn each captive screw clockwise, using a #2 Phillips screwdriver, to tighten the captive screws also
shown in Figure 80.
Extreme Networks Consolidated XOS Hardware Installation Guide

Installing the Aspen 8810 Spare Fan Tray

Fan Tray
Captive
Screws (x2)
Fan Tray
Handle
ASP030A
139