Installing And Removing A Mini-Gbic - Extreme Networks BlackDiamond 8810 Hardware Installation Manual

Mini-GBIC Type and Hardware/Software Support

Installing and Removing a Mini-GBIC

You can add mini-GBICs into, or remove mini-GBICs from your switch without powering off the
system. Figure 10 shows the two types of mini-GBIC connectors.
Figure 10: Mini-GBIC modules
Module A Module B
XM_024
Mini-GBICs are a 3.3 V Class 1 laser devices. Use only Extreme-approved devices.
CAUTION
Mini-GBICs can emit invisible laser radiation. Avoid direct eye exposure to beam.
NOTE
Remove the LC fiber-optic connector from the mini-GBIC prior to removing the mini-GBIC from the switch.
If you see an amber blinking mini-GBIC port status LED, the mini-GBIC installed in your switch or
module is not approved, supported, or certified by Extreme Networks. To correct this problem, install
an Extreme Networks-certified mini-GBIC.
To remove a mini-GBIC similar to the one labeled "Module A" in Figure 10, gently press and hold down
the black plastic tab at the bottom of the connector to release the mini-GBIC, and pull the mini-GBIC
out of the SFP receptacle.
To remove a mini-GBIC connector similar to the one labeled "Module B" in Figure 10, gently rotate the
front handle and pull the mini-GBIC out of the SFP receptacle.
43
Extreme Networks Consolidated XOS Hardware Installation Guide