Table of Contents
Advertisement
BlackDiamond 10808 Switch Overview
To remove a mini-GBIC connector similar to the one labeled "Module B" in Figure 1, gently rotate the
front handle and pull the mini-GBIC out of the SFP receptacle.
To insert a mini-GBIC connector:
NOTE
Mini-GBICs can be installed in the SFP mini-GBIC receptacles only.
1 Holding the mini-GBIC by its sides, insert the mini-GBIC into the SFP receptacle on the switch or
module.
2 Slide the mini-GBIC into the SFP receptacle until you hear an audible click, indicating the mini-GBIC
is securely seated into the SFP receptacle. If the mini-GBIC has a handle, push up on the handle to
secure the mini-GBIC.
XENPAK Module Installation
This section describes installing and removing the XENPAK module, a 10 Gbps optical transceiver. You
can install or remove the XENPAK module from your Extreme Networks switch without powering off
the system. The module is shown in Figure 2.
Figure 2: XENPAK module
The XENPAK module is a Class 1 laser device. Use only Extreme-approved devices on all Extreme
switches.
CAUTION
The XENPAK module can emit invisible laser radiation. Avoid direct eye exposure to beam.
WARNING!
To prevent ESD damage to the XENPAK module, always use an appropriately grounded ESD-preventive
wrist strap when installing or removing the module. Handle the module by its sides only. Never touch the
card-edge connectors at the insertion end of the module.
16
Card edge
connector
EWUG003B
Extreme Networks BlackDiamond 10K-Series Switch Installation Guide
Advertisement
Table of Contents
