Installing And Removing Msms; Installing The Msm - Extreme Networks BlackDiamond 8810 Hardware Installation Manual

BlackDiamond 10K Series Management Switch Module
NOTE
To reset the critical software error LED (amber ERR LED), use the clear log static command and reboot the
switch. If you continue to have critical software errors, or the ERR LED is amber after the clear log static
command and a switch reboot, contact Extreme Networks Customer Support.

Installing and Removing MSMs

This section describes:

Installing the MSM

Verifying the MSM Installation
Removing an MSM
The BlackDiamond 10K series switch comes with eight blank front panels already installed. Use a blank
front panel to fill slots not occupied by I/O modules or switch management modules. For information
about how to install a blank front panel, see
The BlackDiamond 10K series MSM is hot-swappable. You can insert a BlackDiamond 10K series MSM
at any time, without causing disruption of network services. Complete the action of inserting a
BlackDiamond 10K series MSM in a reasonable time frame. Be sure to insert the module completely to
avoid partial connection of backplane connectors.
Installing the MSM
You need the following tools and equipment to install an MSM:
ESD-preventive wrist strap
# 1 Phillips screwdriver
MSM module
To install the MSM:
1 Select a slot for the module:
Slot A or slot B in the BlackDiamond 10K system chassis
CAUTION
You can install MSMs in lettered slots only. MSMs do not fit in numbered slots. Forceful insertion can damage
the MSM.
2 Attach the ESD-preventive wrist strap, that is provided, to your wrist and connect the metal end of
the ESD-preventive wrist strap to the ground receptacle that is located on the top-left corner of the
switch front panel.
3 Remove the blank faceplate from the slot to make room for the module, if applicable.
Extreme Networks Consolidated XOS Hardware Installation Guide
"Installing a Blank Front Panel" on page 98.
80