Power Cable - Power Supply Cords; Argentina; Australia; Denmark - Extreme Networks BlackDiamond 8810 Hardware Installation Manual

Power Cable - Power Supply Cords

Extreme Networks 700/1200 W AC PSU(s) come with both 110 V AC and 220 V AC power supply
cords. The 110 V AC power supply cord allows for a maximum DC output power of 700 W. The 220V
AC power supply cord allows for a maximum DC output power of 1200 W.
The power supply cords provided by Extreme Networks are designed and certified for use in the
United States and Canada only. Power supply cords for use outside of United States and Canada are
typically provided by an third party distribution center and must meet the following requirements.
Power supply cords must be agency certified for country of use.
Power supply cords must contain an appropriate rated and approved wall plug applicable to the
country of installation.
Power supply cords must contain an IEC 320 C13 connector on the PS end of cord.
Power supply cords must be less then 15ft (5m) long.
The minimum specification for the flexible cable is No. 16 AWG (1.0 mm2) copper stranded, Type
SVT or SJT, HAR or equivalent, 3-conductor.
Always use an AC power cable appropriate for your country. Check your local electrical codes and
regulatory agencies for power cable requirements.
The countries listed below have the following additional requirements:

Argentina

The supply plug must comply with Argentinean standards.

Australia

10 A service receptacle, AS 3112 for 110/220 VAC power supplies.

Denmark

The supply plug must comply with section 107-2-D1, standard DK2-1a or DK2-5a.

International

10 A service receptacle, CEE 7/7 for 110/220 VAC power supplies.

Japan

15 A service receptacle, JIS 8303 for 110/220 VAC power supplies.

North America

15 A service receptacle, NEMA 5-15 for 110/220 VAC power supplies.
Extreme Networks Consolidated XOS Hardware Installation Guide
Power Cable - Power Supply Cords
153