Removing The Accessories Box And Preparing The Rack - Extreme Networks BlackDiamond 8810 Hardware Installation Manual

BlackDiamond 10K System Chassis
Figure 21: Tilt watch and shock watch indicators
Tilt watch
CAUTION
If either the tilt watch or shock watch indicator is showing a red, warning condition, do not proceed with unpacking.
Contact your shipping company or Extreme Networks and speak to a representative before continuing.

Removing the Accessories Box and Preparing the Rack

Before you begin unpacking the chassis from the carton, remove the accessories box from the top of the
carton and install the helper bracket into the rack.
The accessories box contains:
19-inch helper bracket for installing the chassis in a rack
ESD-preventive wrist strap
Front bezel for shielding the switch after installation
Documentation and media
To remove the accessories box from the carton:
1 Using a retractable knife, cut away the plastic that wraps the carton.
2 Cut the tape that seals the top of the carton.
3 Open the top carton flaps and remove the accessories box, as shown in
Extreme Networks Consolidated XOS Hardware Installation Guide
Tilt watch
in white state
Tilt watch
in red state
Shock watch
Shock watch
in white state
Shock watch
in red state
Figure 22.
EX_084
64