Xenpak Ports; 10G6X Leds - Extreme Networks BlackDiamond 10808 Hardware Installation Manual

If one MSM is installed in the switch, all ports on the 10G6X module are switched through that MSM. If
two MSMs are installed, the top three ports on the 10G6X module are switched through the MSM in
slot A, and the bottom three ports are switched through the MSM in slot B during normal operation.
The default configuration of the 10G6X module is as follows. All ports:
Are added to the default VLAN as untagged
●
Inherit the properties of the default VLAN (for example, protocol type and VLANid)
●

XENPAK Ports

The 10G6X module supports any of the following XENPAKs:
SR XENPAK
●
LR XENPAK
●
ER XENPAK
●
ZR XENPAK
●
LX4 XENPAK
●
LW XENPAK
●
NOTE
CX4 XENPAKs are also supported with Extreme Networks devices; contact your vendor to obtain these.
NOTE
For more information about the supported XENPAK types and specifications, see the Extreme Networks Pluggable
Interface Modules Installation Guide.

10G6X LEDs

The 10G6X module has the following LEDs:
Module status
●
Port status
●
For information about the LEDs and their activity on the 10G6X module, see
page 29.
BlackDiamond 10808 Switch Hardware Installation Guide
I/O Modules
"I/O Module LEDs" on
25