Using The Cable Holders And Cable Clips - Extreme Networks BlackDiamond 10808 Hardware Installation Manual

BlackDiamond Cable Management
8 Set the bottom edge of the cover on the hinge tabs of the cable manager base (see
the cover into place and press firmly at the top until the latches lock.
Figure 48: Cable Manager Cover Plate
Latches at top of closed cover

Using the Cable Holders and Cable Clips

When you use the cable holders and the cable clips, Extreme Networks recommends the following:
Attach the cables to the holders by slipping the cable through the opening.
●
Connect the cable holders, if you need more than one. (Refer to
●
page 101.)
If you need more than one cable clip for a bundle, connect the clips together before you route the
●
cables through the clips. (Refer to
To form a cable bundle, thread the cables through the clips.
●
Figure 49 shows the cable holders and clips being used to manage a group of cables.
100
Hinge tabs fit into cable manager base
Top view of open/removed cover
"Connecting Cable Clips" on page
BlackDiamond 10808 Switch Hardware Installation Guide
Figure
EX_078
"Connecting Cable Holders" on
102.)
48). Rotate