Gbic, Sfp (Mini-Gbic), Xenpak, And Xfp Regulatory Compliance - Extreme Networks BlackDiamond 10808 Hardware Installation Manual

Safety Information
WARNING!
Laser optic modules become very hot after prolonged use. Take care when removing a laser optic module from the
chassis or option card. If the laser optic module is too hot to touch, disengage the laser optic module and allow it to
cool before removing it completely.
WARNING!
When working with laser optic modules, the following precautions must be followed or hazardous radiation exposure
may occur:
●
Never look at the transmit LED/laser through a magnifying device while it is powered on.
●
Never look directly at a fiber port on the switch or at the ends of a fiber cable when they are powered on.
●
Invisible laser radiation can occur when the connectors are open. Avoid direct eye exposure to the beam
when optical connections are unplugged.
● Never alter, modify, or change an optical device in any way other than suggested in this document.

GBIC, SFP (Mini-GBIC), XENPAK, and XFP Regulatory Compliance

Class 1 Laser Product
●
EN60825-1+A2:2001 or later, European laser standard
●
FCC 21 CFR Chapter 1, Subchapter J in accordance with FDA & CDRH requirements
●
Application of CE Mark in accordance with 89/336/EEC EMC and 73/23/EEC Low Voltage
●
Directives
UL and/or CSA registered component for North America
●
47 CFR Part 15, Class A when installed into Extreme products
●
NOTE
Extreme Networks optics are tested to work in all supported Extreme Networks switches. We recommend that all
customers use Extreme Networks optics in their Extreme Networks switches. Extreme Networks assumes no liability
for third-party optics. While Extreme Networks does not block third-party optics, we cannot ensure that all third-party
party optics operate properly in all Extreme Networks switches. The customer assumes all risks associated with using
third-party optics in Extreme Networks switches.
126
BlackDiamond 10808 Switch Hardware Installation Guide