Repacking a BlackDiamond 10808 Chassis
Required Tools and Equipment
You need the following tools and equipment to repack a BlackDiamond 10808 chassis:
ESD-preventive wrist strap
●
Helper bracket that was shipped with the chassis
●
Four rack-mount screws appropriate to your organization's equipment rack
●
Screwdriver appropriate to the rack-mount screws
●
Original packing materials from the chassis
●
Packing tape
●
Nylon strapping, corner protectors, and crimping tool
●
Repacking the BlackDiamond 10808 Chassis
To recrate the chassis:
1 Attach the ESD-preventive wrist strap to your bare wrist and connect the metal end to the ground
receptacle on the chassis front panel.
2 Remove all modules and power supplies from the chassis. Follow correct Extreme Networks
procedures for removing components.
3 Mount the helper bracket in the rack using four appropriate screws (not provided) (see
Figure 57: Helper Bracket for the BlackDiamond 10808 Chassis
4 With one person on each side of the chassis, remove the chassis from the rack and place it onto the
pallet.
114
EX_086A
BlackDiamond 10808 Switch Hardware Installation Guide
Figure
57).