Repacking a BlackDiamond 10808 Chassis
a Place your thumb and index finger inside the clip lock adjacent to the two vertical prongs (see
Figure
60).
b Press the prongs inward, applying equal pressure on each side.
c Press the prongs into the carton until the clip clicks into place.
Repeat steps 7a through 7c to engage each of the remaining three clip locks.
Figure 60: Installing the Clip Locks
Clip lock
8 Insert the four v-boards in the corners of the crate (see
Figure 61: Inserting the V-Boards
V-boards
9 Close the crate flaps and seal them with packing tape.
116
Squeeze prongs
to unlock
Close
lock
EX_087C
Figure
61).
EX_093A
BlackDiamond 10808 Switch Hardware Installation Guide