Set Voice Mail To Answer At Night; Having Voice Mail Pick Up Unanswered Calls - NEC DS1000 Quick Setup Manual

Press
Part IV: Program the Voice Mail System
VANGARD Mail
To set up VANGARD Mail for DS1000/2000:
1. Following the instructions in your VANGARD Mail manual, connect the Voice Mail system.
2. From the VANGARD Mail Main Menu, enter
3. Enter the VANGARD Mail password (
4. When you see the Install System Menu, enter
NVM-2e
To set up NVM-2e for DS1000/2000:
1. Following the instructions in your NVM-2e manual, connect the Voice Mail system.
2. From any extension:
- Press
- Dial the Voice Mail master number (e.g.,
- (NVM-2e version 2.0 or higher) Dial
- (NVM-2e version prior to 2.0) Dial
3. At the Main Menu, dial
4. Dial
5. Dial
6. Dial
7. Press

Set Voice Mail to Answer at Night

To have the Voice Mail Automated Attendant answer a trunk at night, you program the trunk as a night mode
DIL to the Voice Mail master number. When the attendant presses the NIGHT key, the system switches to
the night mode and the Voice Mail Automated Attendant answers the trunk. During the day, the trunk rings
keysets' line keys normally.
To set up a Night Mode DIL to Voice Mail:
1. Enter the programming mode. You see:
USER: nnn
ENTER PROGRAM?
2. Enter
1003:TRUNK OPTION
TRUNK PORT?n
3. Enter the number of the trunk you want to program (e.g., 1) +
1003: TRUNK PORT?:n
PICK-UP GROUP?n
4. Press
1003: TRUNK PORT?:n
NIGHT TERM?nnn nnnn
5. Enter the Voice Mail master number (e.g., 700) +
6. Press
Press

Having Voice Mail Pick Up Unanswered Calls

There are two ways to set this up:
Method I: Use the system's trunk overflow capabilities.
Method II: Set up Terminal Hunting to Voice Mail.
DS1000/2000 Quick Setup Guide
OR
CONF to exit program 1807.
The steps that follow assume your NVM-2e still has its default programming.
ICM .
DM (36) for the Database Management Menu.
SI (74) for System Initialization.
3 to initialize the Voice Mail database.
4 to install the database for DS1000/2000.
# , then follow the voice prompts to exit.
1003 + HOLD . You see:
VOL Up until you see:
CONF to go back to step 3 and enter another trunk.
OR
CONF twice exit program 1003.
Section 1: Start-up Programming
IN + Enter .
CTL ) + Enter .
7 + Enter (to select DS2000) and follow the prompts.
700 )
301 , wait for the main menu.
10 , wait for the main menu.
HOLD
HOLD .
Section 1: Start-up Programming
. You see:
1
1-13