Setting Up Trunk Access Restrictions - NEC DS1000 Quick Setup Manual

Section 1: Start-up Programming
5. Go back to step 4 and add another trunk to group 0.
Press HOLD to save your entries.
Press HOLD + CONF to exit program 1002.
Part II: Allow Analog Ports to have Full or Outgoing Access to Group 0 Trunks.
1. Enter the programming mode. You see:
USER: nnn
ENTER PROGRAM?
2. Enter 1803 + HOLD . You see:
1803:LINE ACCESS
STATION #?nnn
3. Enter the extension number for the single line telephone you want to program (e.g., 319) + HOLD . You see:
1803:STA:nnn
LINE NUMBER?n
4. Enter the number of the trunk you want to program + HOLD . You see (for the trunk selected):
1803:STA:nnn LINE:n
nnnnnnnnnn
5. Enter access option 2 (outgoing only) or 3 (full/both ways access) for the selected trunk + Vol Up . You
see (for the next trunk):
1803:STA:nnn LINE:n
nnnnnnnnnn
6. Press CONF to return to step 4 and select another trunk to program.
Press CONF twice to return to step 3 and select another extension to program.
Press CONF three times to exit program 1803.

Setting Up Trunk Access Restrictions

The system allows you to set up an "access matrix" for each trunk at each extension. With access restriction,
for example, you could restrict a lobby phone from being able to place outside calls on certain trunks.
To set up trunk access restrictions:
1. Enter the programming mode. You see:
USER: nnn
ENTER PROGRAM?
2. Enter 1803 + HOLD . You see:
1803:LINE ACCESS
STATION #?nnn
3. Enter the number of the extension for which you want to set up access restrictions + HOLD . You see:
1803:STA:nnn
LINE NUMBER?n
4. For the extension selected, enter the number of the trunk for which you want to set up access restric-
tions + HOLD . You see:
1803:STA:nnn LINE:n
nnnnnnnnnnn
1-10 Section 1: Start-up Programming
OR
OR
The previously programmed access setting for the selected trunk displays.
OR
OR
The previously programmed access setting displays.
DS1000/2000 Quick Setup Guide