Call Waiting / Camp-On - NEC DS1000 Quick Setup Manual

5. To enable Barge In, dial
To disable Barge In, dial
6. Press
Part II: Assign the Class of Service with Barge In Enabled to the Extension
1. Enter the programming mode. You see:
USER: nnn
ENTER PROGRAM?
2. Enter
1801:EXTENSION PROG
STATION#?
3. Enter the number of the extension you want to program (e.g., 300) +
1801:STA:nnn
PT TYP?n:nnnnnn nnn
4. Press
1801:STA:nnn
CLASS OF SERVICE?n
5. Enter the Class of Service (1-15) you want to assign to the extension selected +
1801:STA:nnn
CLASS OF SERVICE?n
6. Press
Press
Feature Quick Steps
To Barge-In on a call:
1. Call busy extension or access busy trunk + Dial 4.
2. Join the conversation in progress.

Call Waiting / Camp-On

Call Waiting helps busy extension users know when they have additional waiting calls. It also
lets callers wait in line for a busy extension without being forgotten.
With Call Waiting, an extension user may call a busy extension and wait in line (Camp-On) without hanging
up. When the user Camps-On (by dialing 2), the system signals the busy extension with two beeps indicating
the first waiting call. (The busy extension can be on a handset or Handsfree call.) The call goes through when
the extension becomes free. If an extension has more than one caller waiting, they queue on a first-in/first-
out basis (FIFO). The extension will not hear Camp-On beeps for additional waiting calls. Call Waiting /
Camp-On is enabled by default.
Programming
There are 3 steps to setting up Call Waiting / Camp-On:
Part I: Enable/disable Camp-On system-wide.
Part II: Enable/disable an extension's ability to Camp-On to a busy extension in Class of Service.
Part III: Assign the Class of Service with Camp-On enabled to the extension.
Part I: Enable/Disable Camp-On System-Wide
1. Enter the programming mode. You see:
USER: nnn
ENTER PROGRAM?
2. Enter
0201:TENANT OPTIONS
CALL WAIT?nnn
DS1000/2000 Quick Setup Guide
9 (for yes).
OR
6 (for no).
CONF twice to exit program 0101.
1801 + HOLD . You see:
Vol Up until you see:
CONF and go back to step 3 to select another extension.
OR
CONF twice to exit program 1801.
0201 + HOLD . You see:
Section 2: Customizing Features
Section 2: Customizing Features
HOLD . You see:
HOLD . You see:
2
2-3