Using Keys To Move Around In The Programs - NEC DS1000 Quick Setup Manual

Section 1: Start-up Programming

Using Keys to Move Around in the Programs

Once you enter the programming mode, use the keys in the following chart to enter data, edit data and move
around in the menus.
1-4 Section 1: Start-up Programming
Use this key:
0-9, # and * Enter data into the program.
HOLD
Complete the programming step you just made (like pressing Enter
on a PC keyboard). When a program entry displays, press HOLD to
accept the entry (i.e., bypass the entry without changing it).
CONF Complete the programming step you just made (like pressing
Enter
LND
Delete the entry to the left (like pressing Backspace on a PC key-
board). To delete an entire name entry (without backspacing over
each letter), just reenter the name without pressing LND first.
CLEAR Erase the entire command line you just entered and undefine the
entry.
CHECK
Erase the entry you just made and replace it with the prior stored
entry.
VOL Up Scroll forward through a list of entries in a program. If you enter
data and then press this key, the system accepts the data before
scrolling forward to the next entry.
VOL Down
Scroll backward through a list of entries in a program. If you
enter data and then press this key, the system accepts the data
before scrolling backward to the previous entry.
ICM
Enable the scroll mode. When you press this key and it lights,
you can then press VOL Up and VOL Down to scroll through the
options. To choose the displayed value, press HOLD .
When you want to:
on a PC keyboard) and back up one step in the program.
DS1000/2000 Quick Setup Guide