NEC DS1000 Quick Setup Manual page 30

Section 2: Customizing Features
Specify the System's Home Area Code
1. Enter the programming mode. You see:
USER: nnn
ENTER PROGRAM?
2. Enter 1303 + HOLD . You see:
1303:HNPA CODES
EDIT-E/INIT-I
3. Dial 4 (I) + 9 (Y) to initialize the HNPA table. You see:
1303:HNPA CODES
EDIT-E/INIT-I
4. Dial 3 (E) + 2 (A) to enter the HNPA table edit mode. You see:
1303:ADD CODES
DATA?
5. Enter your home area code (e.g., 203) + HOLD . You see:
1303:HNPA TBL(?=CHK)
nnn
6. Press HOLD again, then CONF twice to exit program 1303.
Feature Quick Steps
To cancel the Caller ID display and return your phone to its normal display:
1. Press CLEAR .
To turn the Caller ID display back on (after you press CLEAR to cancel it):
1. Press CHECK .
To display the Caller ID data for the third party's call (i.e., use Third Party Caller ID Check):
1. Press ICM + CHECK .
2. Press the key for the call you want to check.
3. Hang up when you are done.
To review your Caller ID log:
At Your 22-button and 34-Button Display Keset
1. Press CL nn.
2. Press ALL to review all your records.
Press UNAN to review records for calls that rang your phone but were unanswered in the system.
3. Press Vol Up or Vol Down to scroll through your Caller ID records.
4. Press DIAL to call the person back.
At Your Super Display Keset
1. Press CALLS nn.
2. Press VIEW ALL to review all your records.
Press VIEW UNANS to review records for calls that rang your phone but were unanswered in the system.
Press VIEW ANS to review the records just for calls that rang you phone that were answered in the system.
3. Press Vol Up or Vol Down to scroll through your Caller ID records.
4. Press CALLBACK to call the person back.
2-8 Section 2: Customizing Features
The is the area code in which the system is installed.
You HNPA entry displays.
You can press a line key, loop key, Call Coverage key, or Hotline key:
- Press a line key while the call is ringing or connected to the third party.
- Press a loop key or Call Coverage Key while the call is ringing the third party.
- Press a Hotline key while the call is connected to the third party.
Your Ring/Message Lamp (the large green LED on the upper right corner of your phone) winks
on (green) when you have Caller ID records you have not reviewed.
OR
Press CHECK to toggle your display between its two Caller ID display modes.
OR
OR
DS1000/2000 Quick Setup Guide