Table of Contents
Advertisement
"CLIP"
2
a
1
Socket wrench
Douille
Steckschlüssel
Llave de vaso
"CLIP"
Chiave a bussola
b
Push here
c
Presser ici
Hier drücken
Empujar aqui
Spingere qui
08
"CLIP"
67
5. STARTING THE ENGINE
– Move rotation selector (12) to position "
PRELIMINARY PHASE:
– Press the easy start button (D) (Fig. a).
– Draw mixture into the carburettor by pressing primer (P) 5- 6
times (Fig. b).
With motor cold:
– Move switch (14) to position "
- START " (Fig. c)
With engine hot or in hot environment:
– Move switch (14) to position "
" .
– Lock accelerator (02) in the start position (see § 3.1).
– Give one or two rapid and energetic tugs on the starter cord
(Fig. d).
– Move switch (14) to position "
" .
STARTING:
– Pull the starter cord until the engine starts.
Note: in order to make it easier to pull the starter cord, always press
easy start button before each pull.
To avoid damage, always follow through with the cord as it rewinds and
do not pull it beyond its stroke.
– Allow the wrench to "warm up" for 2 minutes prior to com-
mencement of work.
NOTE: the effective power of the engine will be reached
after settling in over the use of 2 tanks of fuel during which
time the wrench must not be used at top speed and/or for
intense or prolonged periods.
– To switch off the motor, release the accelerator (02), then
move the switch (14) to the "O - STOP" position (Fig. e-f).
e)
f)
14
02
8
ENGLISH
N
" (see § 3.4).
D
P
d)
a)
b)
c)
14
Advertisement
Table of Contents
