Table of Contents
Advertisement
ITALIANO
8. ACCESSORI FORNIBILI A RICHIESTA
– Chiavi a bussola standard e lunghe
di varie tipologie e dimensioni:
(esagonali, quadre, rettangolari)
– Prolunghe
– Adattatori
– Snodi
– Molle di ritenuta "CLIP-NR" cod. 2874205
Per un agevole fissaggio delle chiavi a bussola comunemente
diffuse, aventi diametro di gola compreso fra 47 e 57 mm.
– Molle di ritenuta "CLIP-NR57" cod. 2874206
Per un agevole fissaggio delle chiavi a bussola aventi diametro
di gola compreso fra 57 e 67 mm.
– Valigetta "VAL P20" cod. 2874155
in materiale plastico, adatta al contenimento
degli accessori.
– Custodia metallica tipo "VAL NR" cod. 2874150
Robusta cassa per il trasporto e il contenimento
dell'avvitatore e della valigetta VAL P20.
Before servicing or removing any parts, stop the engine and allow it to cool.
Always remove the spark plug cap from the spark plug when servicing the
engine to prevent accidental starting.
6.1) ORDINARY MAINTENANCE
Avoid placing the wrench on dusty or muddy ground.
After each day's use, carefully clean the wrench with a cloth making sure to remove any
dirt it has picked up, paying particular attention to moving parts and the anvil zone.
Carry out the following operations at regular intervals:
– With the impact wrench in horizontal position, check the level of the oil in the
gearbox/reduction gear through the transparent port (06) (Ref. to Fig. 15a), if
necessary top up (see § 6.2.3).
– Check and if necessary tighten all nuts and bolts.
– Check the rubber shock absorbers which dampen anvil vibrations at the handgrip.
6.1.1) Cleaning the air filter (once a week)
Move switch (14) to position "0" to facilitate removal and insertion of the filter.
– Unscrew knob (C) and remove the cover (Ref. to Fig.13).
– Unscrew the two screws (B) and extract the filter.
– To remove dust and dirt, half open the filter and blow clean using compressed air.
– On completing the cleaning operation, reassemble all parts.
Operating in dusty condition may require more frequent maintenance.
Do not operate the engine with the air filter removed.
6.1.2) Cleaning the spark plug (once a month)
– Unscrew knob (C) and remove the cover (Ref. to Fig.13).
– Disconnect the spark plug cable and remove the rubber ring (G) (Ref. to Fig. 14).
– Unscrew the spark plug using the 19 mm socket supplied.
– Use a wire brush to remove any dirt from the electrode, being careful not to damage
the ceramic support.
– Check, and if necessary, adjust the distance of the electrodes to 0.5 mm.
– Install the spark plug, replace the rubber ring (G), reconnect the cable and assemble
the cover.
– Should the spark plug require changing use ACTIVE RAX80 type or equivalents
(NGK BMR6A ; CHAMPION RCJ8).
6.1.3) Cleaning the fuel filter (once every 6 months)
– Using the 4 mm Allen wrench supplied, remove the red side protection shield by un-
screwing the fixing screws (Ref. to Fig. 12a).
65
10
6. MAINTENANCE
ENGLISH
Advertisement
Table of Contents
