Table of Contents
Advertisement
Step 1. Connect the logic analyzer to a host
computer (PC)
1 Connect the small end of an HP C2946A parallel port printer
cable to the PARALLEL connector on the rear panel of the logic
analyzer
2 Connect the large end of the printer cable to the PC's parallel
port.
3 Apply power to the PC if it is not turned on.
To ensure the PC's parallel port is properly configured, interrupt the
PC's boot process by pressing [ F2 ] on the keyboard. Scroll down to
the parallel port configuration and observe the current parallel port
data transfer mode. Ensure either Enhanced Capabilities Port (ECP),
Byte, or Nibble mode is selected (Enhanced Parallel Port (EPP) mode
will not work). If none of the correct transfer modes is selected, you
need to change the transfer mode according to the instructions for
your PC.
Chapter 1: Setting Up LogicWave
Installing LogicWave
7
Advertisement
Table of Contents
