H3C MSR 810 Command Reference Manual page 44

displays information about the specified interface. For more information about VA interfaces, see
PPPoE configuration in Layer 2—WAN Access Configuration Guide.
: Display brief interface information. If you do not specify this keyword, the command displays
brief
detailed interface information.
description
command displays only the first 27 characters of interface descriptions.
: Displays interfaces that are physically down as well as the down reason. If you do not specify
down
this keyword, the command does not filter output by physical interface state.
Examples
# Display information about VSI-interface 100.
<Sysname> display interface vsi-interface 100
Vsi-interface100
Current state: UP
Line protocol state: UP
Description: Vsi-interface100 Interface
Bandwidth: 1000000 kbps
Maximum transmission unit: 1500
Internet address: 10.1.1.1/24 (primary)
IP packet frame type: Ethernet II, hardware address: 0011-2200-0102
IPv6 packet frame type: Ethernet II, hardware address: 0011-2200-0102
Physical: Unknown, baudrate: 1000000 kbps
Last clearing of counters: Never
Last 300 seconds input rate: 0 bytes/sec, 0 bits/sec, 0 packets/sec
Last 300 seconds output rate: 0 bytes/sec, 0 bits/sec, 0 packets/sec
Input: 0 packets, 0 bytes, 0 drops
Output: 0 packets, 0 bytes, 0 drops
Table 8 Command output
Field
Current state
Line protocol state
Description
Bandwidth
Maximum transmission unit
Internet protocol processing: Disabled
Internet address:
ip-address/mask-length (Type)
: Displays complete interface descriptions. If you do not specify this keyword, the
Description
Physical link state of the interface:
•
Administratively DOWN—The interface has been shut down
by using the shutdown
•
DOWN—The interface is administratively up, but its physical
state is down.
•
UP—The interface is both administratively and physically up.
Data link layer state of the interface:
•
UP—The data link layer protocol is up.
•
UP(spoofing)—The data link layer protocol is up, but the link
is an on-demand link or does not exist.
•
DOWN—The data link layer protocol is down.
Description of the interface.
Expected bandwidth of the interface.
MTU of the interface.
The interface is not assigned an IP address and cannot process IP
packets.
IP address of the interface and type of the address in parentheses.
Possible IP address types include:
38
command.