Stopping Conditions And Recovery Steps - CUMMINS ALLISON JetScan iFX i100 Operating Instructions Manual

Stopping Conditions and Recovery Steps

The following conditions cause the machine to stop and require action by the user.
Condition
The machine detected documents
that were not adequately spaced
apart.
Condition
The screen above (left) will appear
when the piece count for day
totals reaches 350,000.
Remove all documents from the pocket and put them on the hopper. Press
CONT.
If an alarm repeatedly occurs, adjust the gray thickness dial on top of the
machine behind the hopper extension. Rotate in the negative (-) direction as
indicated by the numbers on the front of the thickness dial.
Day Total Limit Warnings
Press OK to return to the main screen. Navigate to the MAIN SUB-MENU, press
REPORT MENU and press DAY REPORT to prompt the DAY TOTALS screen.
Clear day totals. The screen above (left) will continue to appear after each
subsequent batch is ended until day totals are cleared.
If the screen above (left) is ignored, and the piece count reaches 400,000, the
screen above (right) will appear. The screen above (right) will continue to
appear each time documents are placed in the hopper until day totals are
cleared.
© 2013 Cummins-Allison Corp.
Action
Action
89