Statement Of Agency Compliance; Fcc Class A Compliance Statement; Safety Compliance - CUMMINS ALLISON JetScan iFX i100 Operating Instructions Manual

Statement of Agency Compliance

This device complies with part 15 of the FCC rules. Operation is subject to the following two
conditions: (1) this device may not cause harmful interference, and (2) this device must accept any
interference received, including interference that may cause undesired operation.

FCC Class A Compliance Statement

Radio frequency present.
Install and operate per manuals to avoid radio interference.
Unapproved changes to machine may void user's right to operate.
Do not modify without express permission from Cummins-Allison Corp.
Attach only shielded cables with shield wires grounded (tied) to connector shell.
Install ferrite bead on all external communication cables; position ferrite bead
near external port.
This equipment has been tested and found to comply with the limits for a Class A digital device,
pursuant to part 15 of the FCC rules. These limits are designed to provide reasonable protection against
harmful interference when the equipment is operated in a commercial environment.
This equipment generates, uses, and can radiate radio frequency energy and, if not installed and used in
accordance with the instruction manual, may cause harmful interference to radio communications.
Operation of this equipment in a residential area is likely to cause harmful interference, in which case
the user will be required to correct the interference at his own expense.
Any changes or modifications made to this device that are not expressly approved by Cummins-Allison
Corp. may void the user's authority to operate the equipment.
To maintain compliance with FCC rules and regulations, cables connected to this device must be
shielded cables in which the cable shield wires are grounded (tied) to the connector shell.
To meet the requirements of EN 55022 Class A, a ferrite bead recommended by Cummins or an
equivalent must be installed on all external communication cables. The ferrite bead must be positioned
as close as possible to the machine's external port.

Safety Compliance

• U.L. file number: E135004 NWGQ Information Technology Equipment Including Electrical
Business Equipment
The CE mark on the product indicates that the system has been tested to and conforms to the
provisions noted within the 2004/108/EC (EMC) and 2006/95/EC (LVD) directives.
EN 60950-1 European Norm, Safety of Information Technology Equipment Including Electrical
Business Equipment
U.L. 60950, Third Edition and CAN/CSA – C22.2 No. 950-95
022-7614-00 – Rev. H 05/2013