Operating Mode Descriptions - CUMMINS ALLISON JetScan iFX i100 Operating Instructions Manual

14

Operating Mode Descriptions

The machine provides four modes of operation for processing documents. The SETUP menus
provide options for enabling/disabling the modes. Only the modes enabled in SETUP appear on
the MODE-SELECTION screen; disabled modes are not available for use. When the machine is
turned ON, it defaults to the mode it was in when last turned OFF.
To view the MODE-SELECTION screen, press MODE on the main screen. An example of the
MODE-SELECTION screen is shown below. All modes are described in the following table.
Mode Key
STRANGER
MIXED
Note processing: Scans for the first denomination processed, which is the
target, and stops when another denomination is found. When the machine
encounters a different denomination, it is called a stranger. A grand total is
provided.
Check processing: The machine assumes checks are in the hopper. When the
machine encounters a note, it is presented as a no call with a prompt to enter a
MICR number. Remove the note from the pocket and press CONT. Check order
integrity settings determine feed error behavior. (See
more information.) A grand total piece count is provided.
Ticket processing: Scans for a bar code and rejects documents without a bar
code as strangers. Use this mode for batching (strapping) tickets. A grand total
piece count is provided.
At this time, notes and checks cannot be processed
together in MIXED mode.
Note processing: Scans all denominations without presorting. A grand total by
denomination is provided.
Check processing: Scans checks and is best used when batching (strapping)
checks is not required. Check order integrity settings determine feed error
behavior. (See Check Setup Menu 2 for more information.) A grand total piece
count is provided.
Note and ticket processing: Scans notes and tickets and is best used when
batching (strapping) is not required. A grand total for notes and ticket piece
counts is provided.
JetScan iFX ® i100 Scanner
Description
Check Setup Menu 2
All Models
for