CUMMINS ALLISON JetScan iFX i100 Operating Instructions Manual page 90

88
9.
10.
Use a dry microfiber towel to clean the stacking sensor.
11.
Next, use a dry microfiber towel to clean the stacking-sensor reflector, which is located on the
upper-transport plate directly above the stacking sensor.
Press down on the release levers to unlock the upper-transport plate from the open position.
12.
Press down on the upper-transport plate until it locks in the closed position.
13.
Lower display panel to the operating position.
14.
Use a dry microfiber towel or vacuum to remove any remaining dust in the pocket.
Use a dry microfiber towel to clean the pocket-sensor lens located in the pocket between the two
gray stacker wheels.
15.
Next, use a dry microfiber towel to clean the pocket mirror located directly across from the
pocket-sensor lens.
16.
Clean the touch-panel display with a dry microfiber towel.
17.
Clean remaining hard-plastic exterior surfaces as necessary with a Simple Green Safety Towel.
18.
Return hopper to the operating position.
19.
Carefully reconnect power cord.
20.
Turn power ON (rocker panel to I).
21.
Perform a test run with some documents.
Vacuum underneath the
upper-transport plate (shown
at left), as well as the top of
the lower-transport plate
(shown at right).
Image sensor
Image sensor
Avoid damaging touch-panel display.
Only clean touch-panel display with dry microfiber towel as
directed.
JetScan iFX ® i100 Scanner
Use a dry microfiber towel to wipe buildup off
the image sensors shown at left.
All Models