CUMMINS ALLISON JetScan iFX i100 Operating Instructions Manual page 31

Adjustment Menu Key
DENSITY ADJ
(Density Adjustment)
Prompts the DENSITY ADJUSTMENT screen shown below.
Density levels, or doubles-detection sensitivity, may be set for documents
and the COUNT mode. These settings should be adjusted before
processing.
To change density levels:
1. Press  or  to select the desired density setting for a denomination
or document. The first digit in the DENOM column indicates the
denomination. The digit after the decimal indicates the note series.
To view additional density settings, press the double down arrows.
2. Use + and – to select a level (1 - 5 or OFF).
The lower the number, the less sensitive the setting
is. The higher the number, the more sensitive the
setting is. The ideal sensitivity level depends on
overall document condition.
3. Repeat steps 1 and 2 for each document type as needed.
4. When finished, press EXIT to return to the ADJUSTMENT MENU.
© 2013 Cummins-Allison Corp.
Description
29