Telephone Programming - Panasonic VL-V901 Series Installation And Operating Instructions Manual

5. Programming
Parameter
SIGNAL TIME TO LIFT
SET ACCESS CODE
*1 For systems that support enhanced features version 2 or later (page 92)
Buildings must be registered. The settings can be used to change how many buildings are registered at each
lobby station.
Configure the room number settings after configuring the building number settings.
Parameter
SET BUILDING NO.
BUILDING NO.
CONTROL BOX NO.
Parameter
SET ROOM NO.
*2 For systems that support enhanced features version 3 or later (page 92)
When a lobby station is unlocked, a notification sound can be sent from the lobby station depending on the
settings.
Parameter
SET DOOR KEY
DOOR KEY OPEN TIME
DOOR KEY OPEN SOUND

5.4 Telephone programming

Use this procedure to configure the following settings.
62
Description and available settings
After a visitor is admitted, this setting determines the
amount of time that the visitor can use the lift to visit the
corresponding floor.
If the lift has a similar setting, set this parameter to any
value other than "0"; the lift's box setting will take
priority.
(001–900 SEC, or 000 to disable)
Determines the access code that allows you to use
lobby stations to configure the system.
(6 digits)
Description and available settings
Registers the building number of a building.
A maximum of 20 buildings can be registered.
A maximum of 3 digits can be used (1–999).
Determines the control box (1-4) to be linked to the
building number.
Description and available settings
Determines the room number, resident name, and
building number.
(1–99999, 20 characters max., lowercase letters not
available, 1–999)
R The building number must be configured in
advance.
R See Entering numbers and characters (Page 58)
for more information.
Description and available settings
Determines the amount of time the door stays open.
If set to 0 SEC, the door cannot be opened.
(01–20 SEC, or 00 to disable)
Sends a notification sound to the lobby station when
unlocking a door. (A notification sound is also sent
when access controller (door opener, key switch,
card reader, etc.) unlocks a door.)
[00]: NO
[01]: YES
Default
300
(300 SEC)
123456
Default
1
1
Default
—
Default
05
(5 SEC)
00
(NO)