Connecting Other Devices - Panasonic VL-V901 Series Installation And Operating Instructions Manual

4. Installation

4.6 Connecting other devices

4.6.1 Connecting electric locks
An electric lock can be connected to the electric lock connection terminal located on the rear of the lobby station
(page 14).
R One electric lock can be connected to each lobby station.
R After connecting an electric lock to the lobby station, confirm that the door can be properly locked and unlocked
using the main monitor.
4.6.2 Connecting to a PBX
The control box can be connected to a Panasonic PBX. Use the RJ11 jack located on the side of the control box
(page 15) to connect it to an extension port of the PBX. Consult your certified Panasonic dealer for more information.
R The control box can be connected to only one PBX.
R For information on how to connect extensions telephones to the PBX, see the operating instructions included with
the PBX.
– 4 extension numbers of the PBX can be registered with the control box for use by facility staff, receptionists,
etc.
– One extension number of the PBX can be registered with the control box for use as the emergency terminal.
R Configure settings so that the caller's extension number is notified for each terminal connected to the PBX. Refer
to the documentation provided with the PBX for more information.
R The system software saved in the control box is software for use with either analog PBXs or digital PBXs. You
can determine which software is saved to the control box by checking the suffix of the serial number label attached
to the control box. (Refer to 7.5.2 Serial number suffixes (Page 89) for information on suffixes and the types of
PBX software available.)
If the type of software saved to the control box does not match the type of PBX being used, download the type of
system software that matches the PBX type to the control box. (Updating is not required if the type of PBX and
system software match.)
– Download information is available at the following web site.
https://panasonic.net/cns/pcc/support/intercom/v900
– Refer to 5.10 Upgrading the system software (Page 78) or consult your certified Panasonic dealer for
information about upgrading the system software.
4.6.3 Connecting to lifts
A lift can be connected to the lift connection terminals located on the side of the lift controller (page 16). For information
on how to connect lifts to the lift controller, refer to the operating instructions included with the lift.
R Up to 3 lifts can be controlled.
4.6.4 Connecting cameras
A camera can be connected to the coaxial connector located on the rear of the lobby station (page 14).
R One camera can be connected to each lobby station.
R Compatible cameras:
– Cameras that support PAL or NTSC video signals. Consult your certified Panasonic dealer for more
information.
4.6.5 Connecting a TV monitor
A TV monitor can be connected to the coaxial connector located on the side of the control box (page 15).
R One TV monitor can be connected to the control box.
R Note that the control box can only output NTSC video signals to the TV monitor.
R Compatible TV monitors:
– TV monitors that support NTSC video signals. Consult your certified Panasonic dealer for more information.
44