Table of Contents
Advertisement
5. Programming
5.2.6 Using the version 2 or 3 setup tool to edit data
For systems that support enhanced features version 2 or later (page 92)
The following settings can be configured.
– Settings for increasing the number of control boxes connected to extension boxes
R Building settings
R Settings for increasing the number of room units
– Gate call settings, etc.
For systems that support enhanced features version 3 or later (page 92)
The following settings can be configured.
– When relay signalling is used by the lift controller, settings for stopping on multiple floors for all lifts (up to 5 separate
floor settings) are supported.
– An "Open code" for unlocking the lobby station can be configured for each resident.
– When a lobby station is unlocked, a notification sound can be sent from the lobby station depending on the settings.
1
Start the setup tool.
2
In the [Prepare the data] section, click [Check Files].
R The paths of each configuration file are displayed in the [Load and edit the data] section.
R When there are multiple control boxes used in the system and you want to download data from the system's
devices, you must specify which control box (1-4) you are connected to.
3
In the [Load and edit the data] section, click [Load / Edit ...] next to a configuration file that you want to edit.
R The files's details are displayed.
4
When directly editing CSV files:
a. Click [Edit ...] to open the configuration file.
R Use a third-party text editor or spreadsheet program to open the configuration file.
b. Change the values in the appropriate columns, and then save and close the file.
c. In the setup tool, click [Reload].
R The content of the configuration is reloaded and displayed.
d. Click [Close].
When editing individual settings:
a. Select the desired setting.
b. Enter the desired value in the [Edit Data] section.
R Acceptable values are displayed in a pop-up when you mouse-over the text field.
c. Click [Apply / Save] to save the settings to the configuration file.
d. Click [Close].
5
Repeat from step 3 for each configuration file that you want to edit.
R Files that are ready to be uploaded are indicated by [OK] displayed in the right side of the [Load and edit the
data] section.
6
In the [Upload the data to device] section, select the devices that you want to upload the data to and then click
[Upload].
R When there are multiple control boxes used in the system and you want to upload data to the system's devices,
you must specify which control box (1-4) you are connected to.
5.2.7 Downloading and backing up data
You can download the data that is saved in the system's devices, and back them up on your computer.
1
Start the setup tool.
2
In the [Prepare the data] section, turn on the checkboxes for the desired devices listed under [Download the
data from].
3
Click [Download].
R The data from the selected devices is downloaded to your computer and overwrites the configuration files
saved on your computer.
R Refer to the [Select folder] section and note the location of the configuration files.
4
Backup the configuration files as needed.
50
Advertisement
Table of Contents
