Table of Contents
Advertisement
5.2.8 Editing configuration files directly
You can edit large amounts of data by editing configuration files directly.
1
Start the setup tool.
2
Refer to the [Select folder] section and note the location of the existing configuration files.
R If you want to create new configuration files in a different folder, create the folder on your computer, select the
folder in the [Select folder] section, and then click [Create Files] in the [Prepare the data] section.
R For systems that support enhanced features version 2 or later (page 92)
When there are multiple control boxes used in the system and you want to download data from the system's
devices, you must specify which control box (1-4) you are connected to.
3
Using your computer's file explorer, open the folder containing the existing configuration files.
4
Open the desired configuration file.
R Use a third-party text editor or spreadsheet program to open the configuration file.
5
Change the values in the [Data] column as desired, and then save and close the file.
R Acceptable values are explained in the [Data Note] column.
R Descriptions of each setting and other information are explained in the [Item Note] column.
R See 5.2.13 List of PC programming parameters (Page 53) for information about each parameter.
6
Using the setup tool, click [Check Files] the [Prepare the data] section.
R The paths of each configuration file are displayed in the [Load and edit the data] section.
7
In the [Load and edit the data] section, click [Load / Edit ...] next to a configuration file that you want to upload.
R The files's details are displayed.
R For systems that support enhanced features version 2 or later (page 92)
When there are multiple control boxes used in the system and you want to upload data to the system's devices,
you must specify which control box (1-4) you are connected to.
8
Click [Close].
9
Repeat from step 7 for each configuration file that you want to upload.
R Files that are ready to be uploaded are indicated by [OK] displayed in the right side of the [Load and edit the
data] section.
10
In the [Upload the data to device] section, select the devices that you want to upload the data to and then click
[Upload].
5.2.9 Setting the control box's date and time
1
Start the setup tool.
2
In the [Time and date settings] section, click [Time and Date Settings (Control Box)].
3
Set the date and time, and then click [Set to Control Box].
5.2.10 Configuring the main monitors
After you have configured the settings in the [Control Box — Room settings], use the following procedure to apply
these settings to the main monitors.
1
Start the setup tool.
2
In the [Connection Check] section, click [Check Main Monitor (Set General Data)], and then click [Execute].
5.2.11 Confirming the control box's connection to the lift controllers
1
Start the setup tool.
2
In the [Connection Check] section, click [Check Lift Controller].
5. Programming
51
Advertisement
Table of Contents
