Panasonic VL-V901 Series Installation And Operating Instructions Manual page 59

1. Press M#N ® enter the access code ® M
For systems that support enhanced features version 2 or later (page 92)
a. Enter the building number ® M
b. Press M#N enter the access code ® M
R The default access code is "123456".
2. Select "SET ACCESS CODE" ® M
3. Enter the desired 6-digit code ® M
4. Press M N.
Changing open codes
For systems that support enhanced features version 3 or later (page 92)
When "Open codes" for unlocking the lobby are configured for each resident with the PC setup tool, "Open codes"
can also be changed with Lobby station programming.
In order to use this feature, "Open code" settings must be configured in advance from the PC setup tool. See
page 58.
Important:
R To prevent intruders from entering the building, make sure to select open codes that are difficult to guess,
change them regularly, and keep them secret. Inform all relevant staff and residents of these policies.
R When the open code is changed to "#### (Disable)", it must be configured from the PC setup tool the next
time you use it.
1. For 1 building systems:
Enter the resident's room number.
For multiple buildings systems:
a. Enter the resident's building number.
b. Press M N.
c. Enter the resident's room number.
2. Press M#N.
3. Enter your current (configured) 4-digit open code.
R Confirm the 4-digit open code with the facility staff.
4. Press MHN M#N M N.
5. Enter your desired 4-digit open code ® M
5.3.1 List of lobby station programming parameters
The following parameters are available when using lobby station programming.
Note:
R You can also use PC programming to configure these settings for each main monitor. Parameter names are slightly
different when using PC programming.
Parameter
*1
SET ROOM NO.
DELETE ROOM NO.
*2
SET DOOR KEY
DOOR KEY OPEN TIME
N.
N.
N.
N.
N.
N.
Description and available settings
Determines the room number and resident name.
(1–99999, 20 characters max., lowercase letters not
available)
R See Entering numbers and characters (Page 58) for
more information.
Deletes the room number and resident name.
(1–99999)
Determines the amount of time the door stays open. If
set to 0 SEC, the door cannot be opened.
(01–20 SEC, or 00 to disable)
5. Programming
Default
—
—
05
(5 SEC)
59