Basic Settings - Panasonic VL-V901 Series Installation And Operating Instructions Manual

4.7 Basic settings

The following is a list of basic settings we recommend that you configure before using the system. Most items can be
configured using PC programming, but other programming methods may be available. See the programming chapter
(page 46) for details.
R For the control box
– Date and time
Configure using PC programming (5.2.9 Setting the control box's date and time (Page 51))
– Room number and other information for each room
Configure using PC programming (Control Box — Room settings (Page 53))
– General system settings
Configure using PC programming (Control Box — General settings (Page 53))
For systems that support enhanced features version 2 or later (page 92)
When there are multiple control boxes used in the system and you want to download data from the system's
devices, you must specify which control box (1-4) you are connected to.
R For lobby stations
– General settings stored in each lobby station
Configure using PC programming (Lobby Station 1–3 — General settings (Page 54))
– Room number and name stored in each lobby station
Configure using PC programming (Lobby Station 1–3 — Room settings
For systems that support enhanced features version 2 or later (page 92)
When there are multiple control boxes used in the system, building settings must be configured before room
settings.
R For distribution boxes
– DIP switch settings
Configure using the device's DIP switches (4.5.4 Distribution box switch settings (Page 37))
R For lift controllers
– DIP switch settings
Configure using the device's DIP switches (4.5.5 Lift controller DIP switch settings (Page 42))
– Lift access permissions for each room
Configure using PC programming (Control Box — Room settings (Page 53))
– Confirming the connection
Perform using the setup tool (5.2.11 Confirming the control box's connection to the lift controllers
(Page 51))
R For main monitors
– Room number and other information for each room
We recommend using PC programming for initial setup (Control Box — Room settings (Page 53). You can
change these settings on a room by room basis using main monitor programming if necessary (5.5 Main
monitor programming (Page 64)).
– Applying room settings to the main monitors
Perform using the setup tool (5.2.10 Configuring the main monitors (Page 51))
R For electric locks and access controllers
– Door open times, codes, signals types, and various other settings
Configure using PC programming (Lobby Station 1–3 — General settings (Page 54))
R For terminals
– Extension numbers, terminal names, and various other settings
Configure using PC programming (Control Box — General settings (Page 53))
4. Installation
,
(Page 54))
45