Table of Contents
Advertisement
2. Press and hold the MRESETN button for about 3 seconds, then release the MRESETN button only.
R The main monitor starts up and enters programming mode.
3. When the display lights up, release all the buttons.
4. Press the
or
R The main monitor initialises its settings.
R While performing the next steps, you can cancel without saving your settings by pressing M
5. Enter the room number.
a. Press
or
b. Press
to accept the entered number and advance the cursor.
c. Press
when finished.
6. Enter the floor number.
a. Press
or
b. Press
when finished.
7. Set the visitor lift permissions for "Lift 1".
a. Press
or
b. Press
to select the next lobby station.
c. Press
when finished.
R Repeat the above procedure for "Lift 2" and "Lift 3".
8. Confirm the displayed settings.
R Press
to go back and enter the desired settings again.
9. Press
to check for a duplicate room number.
R If a duplicate room number is found, press
existing room number settings.
If no duplicate is found, the settings are saved in the control box.
Note:
R If you press
the settings in the control box, press
R When the mode (House mode or Apartment mode) of the main monitor is changed, the extension monitor
automatically changes modes to match the main monitor.
When programming the VL-MV74
1. Press M
N once. While pressing and holding the lower M N button on the right side of the main monitor, press
and hold the MRESETN button on the left side for about 3 seconds, then release the MRESETN button only.
R Continue to hold the lower M N button and perform the next step.
2. When the screen turns a whitish colour, release the lower M N button.
3. Press each of the following buttons once each in the following order.
N ® M
N ® M N
M
R The main monitor starts up and enters programming mode.
4. Press the
or
R The main monitor initialises its settings.
R While performing the next steps, you can cancel without saving your settings by pressing M
5. Enter the room number.
a. Press
or
b. Press
to accept the entered number and advance the cursor.
c. Press
when finished.
6. Enter the floor number.
a. Press
or
b. Press
when finished.
soft keys to select "Apartment mode" ®
to select the desired number.
to select the desired number.
to allow or prohibit lift usage for visitors to each lobby.
, the settings will be saved in the main monitor only, and the main monitor will restart. To save
soft keys to select "Apartment mode" ®
to select the desired number.
to select the desired number.
or
to select whether you want to overwrite the
.
5. Programming
.
N.
.
N.
67
Advertisement
Table of Contents
