Table of Contents
Advertisement
5. Programming
7. Set the visitor lift permissions for "Lift 1".
a. Press
or
b. Press
to select the next lobby station.
c. Press
when finished.
R Repeat the above procedure for "Lift 2" and "Lift 3".
8. Confirm the displayed settings.
R Press
to go back and enter the desired settings again.
9. Press
to check for a duplicate room number.
R If a duplicate room number is found, press
existing room number settings.
If no duplicate is found, the settings are saved in the control box.
Note:
R If you press
the settings in the control box, press
R When the mode (House mode or Apartment mode) of the main monitor is changed, the extension monitor
automatically changes modes to match the main monitor.
5.5.1 List of main monitor programming parameters
The following parameters are available when using main monitor programming.
Note:
R You can also use PC programming to configure these settings for each main monitor. Parameter names are slightly
different when using PC programming.
Parameter
ROOM NUMBER
FLOOR NUMBER
LIFT 1
LIFT 2
LIFT 3
68
to allow or prohibit lift usage for visitors to each lobby.
, the settings will be saved in the main monitor only, and the main monitor will restart. To save
Description
Tells the system what room the main monitor is
installed in.
(1–99999)
Tells the system what floor the main monitor is installed
on.
(0–99; 0 is the ground floor)
Determines which lifts can be used by visitors to each
lobby station.
(Yes, No)
or
to select whether you want to overwrite the
.
Default
—
—
No
(No lifts can be
used)
Advertisement
Table of Contents
