Cabletron Systems CBU-NM User Manual page 50

CBU-NM
User Manual
6.5.2 * Set up the TCP/IP Network
If you are using the SNMP Link, you will need to configure the network to
support TCP/IP. If not, skip to section 6.5.3.
6.5.2.1 * Install the Network hardware
If you do not have one already, you will need to install a Network
Interface card on your PC. This card should have an NDIS (Network
Device Interface Specification) driver.
6.5.2.2 * Configure the NDIS driver
This driver is the software that allows multiple protocol stacks to share a
single Network Interface card. It may need to be configured with an IRQ
number and other information before the card can be used. Refer to the
manual supplied with the driver for details.
6.5.2.3 * Install Chameleon
The Chameleon
a group of programs designed to communicate with a wide variety of
network systems. This software allows PCNC to communicate over a
TCP/IP network, and it contains integrated SNMP support.
Section 5.5 for details of how to set it up.
6.5.3 Install the files
Create a new directory (the 'working directory', usually called C:\PCNC)
where all the application's files will be stored.
Copy all the files from the distribution Disks 1 and 2 to the working
directory.
6.5.3.1 * Install the optional SNMP extensions
If you are using the SNMP Link, you will also need to copy the files from
the SNMP extensions disk into your working directory. These extension
files allow PCNC to communicate with Chameleon .
6–4 ii
TCP/IP for Windows package from NetManage is
See
80-60100000-02