Directconnecttimeout=<Integer; Auxiliary Link]; Columncount=<Integer - Cabletron Systems CBU-NM User Manual

CBU-NM
User Manual
When enabled, the handshaking scheme is designed to
operate with PCNC connected to the Master port of a
Cabletron port sharer (PSV). For additional details including
cabling requirements, see Chapter 14.
7.8.6 DirectConnectTimeout=<integer>
120
Default:
Purpose: Specifies the delay (in seconds) that a direct connection can
be left online and inactive before the Cabletron Network
Controller automatically disconnects it. The entry can take
any value in the range 30 to 3600.

7.9 [Auxiliary Link]

All settings in this section are required for PCNC to connect to Auxiliary
devices. Only the Port entry is required if you do not need to use the
Auxiliary Link.
Some of the entries in this section have a format identical to those in the
[Control Link] section. These are: Port, LineCount, RxQueueSize and
TxQueueSize. Their default values, range of values and purpose are
the same, but apply to the Auxiliary Terminal, rather than to local
connections and the Control Terminal.
Only the settings that apply specifically to the Auxiliary Link are
described here, but you must still have an entry for Port, LineCount,
RxQueueSize and TxQueueSize in the [Auxiliary Link] section in order
to use it. Of course, if you are using more than one Link, you must
nominate a different Port name for each one.
7.9.1 ColumnCount=<integer>
Default: 80
Purpose: This entry specifies the number of columns which the
Auxiliary Terminal window will use.
ColumnCount can be between 40 and 256.
ii 7–6
The value of
80-60100000-02