Table of Contents
Advertisement
7.8.2 LineCount=<integer>
24
Default:
Purpose:
This entry controls the number of lines that appear in the
Control Terminal window. The value of LineCount can be
between 24 and 128. Change the setting if you need to see
more than 24 lines of history in the Control Terminal window.
7.8.3 RxQueueSize=<integer>
Default:
512
Purpose:
This entry defines the number of characters which can be
stored in the Control Link queue, ready to be processed.
The Cabletron Network Controller temporarily queues
incoming characters if it is busy processing another task.
The value of RxQueueSize can be between 256 and 32767.
NB: Values greater than 512 can cause problems with the
Windows COM Driver if used with the 16550 UART, and
should not be set if you are using this Driver.
7.8.4 TxQueueSize=<integer>
4096
Default:
Purpose:
This entry sets the size of a queue used to hold outgoing
characters for the Control Link. The value of TxQueueSize
can be between 256 and 32767.
7.8.5 Handshaking=<boolean>
Off
Default:
Purpose:
Specifies whether or not Control Link handshaking should be
used. Valid entries are On and Off .
The Control Link handshaking feature helps to protect the
Control Link against overloading under high levels of alarm
traffic. Without it, if PCNC receives a stream of alerts faster
than it can process them, alarm data will be lost. By default,
handshaking is disabled, to retain compatibility with previous
versions.
80-60100000-02
Configuring PCNC.INI
7–5
Advertisement
Table of Contents
