Device Drivers]; Options]; Audiblewarningbutton=<Boolean; Continuousaudiblewarning=<Boolean - Cabletron Systems CBU-NM User Manual

7.11 [Device Drivers]

This section was used in PCNC before version 0.27. It is no longer
needed and should not appear in PCNC.INI.

7.12 [Options]

Any entries that do not have their own section will be in the
miscellaneous [Options] section.
7.12.1 AudibleWarningButton=<boolean>
Default: Available
Purpose: Enables or disables the command to toggle the Audible
warning. Valid entries are Available and Unavailable .
If Unavailable is specified, PCNC prevents you from turning
the Audible warning off and on. The Alarms | Audible
warning command and its toolbar button are then coloured
grey, and clicking on them will have no effect.
You can use this behaviour to set the Audible warning to
'always sounds' or 'never sounds'. Select the desired setting
while the command is enabled, then disable it in PCNC.INI
and re-load the program.
7.12.2 ContinuousAudibleWarning=<boolean>
Default: On
Purpose: Controls the operation of the Audible warning. Valid entries
are On or Off .
The Audible warning is activated by new alarms. It remains
active until all alarms are acknowledged, or until it is turned
off using the Alarms | Audible warning command.
When it is active, the Audible warning sounds continuously if
this option is On .
If the option is Off , the Audible Warning sounds continuously
for the first minute, after which it sounds once every minute.
After five minutes, it sounds every three minutes.
80-60100000-02
Configuring PCNC.INI
7–9