Cabletron Systems CBU-NM User Manual page 71

9.1 This chapter
This chapter tells you how to set up the equipment in your network to
work with PCNC. Read this only if you need to set up new equipment.
9.2 Introduction
Most Cabletron devices have various settings that may need to be
configured before they can communicate with PCNC.
describes the PCNC-compatible options for Cabletron products.
In all products the command port will need to configured with a data rate
of 9600, no parity, 1 stop bit and 8 data bits.
Equipment directly connected (or via a port sharer network) must have
its command port set up as in the following sections. Please consult the
individual product manuals for details of how to achieve these settings.
80-60100000-02
9 Equipment setup
Equipment setup
This section
9–1