Installing The Cutting Units - Toro 03966 Operator's Manual

1. Loosen the 2 bolts securing the control arm to
the retaining bracket
1. Control arm
2. Retaining brackets
2. Rotate the control arm to the desired position
and tighten the 2 bolts.
3

Installing the Cutting Units

Parts needed for this procedure:
1 Right front hose guide
1 Left front hose guide
Preparing the Machine
1. Remove the reel motors from the shipping
brackets.
2. Remove and discard the shipping brackets.
3. At each cutting unit lift arm, remove the snapper
pin that secures the cap to the lift arm pivot
yoke, and remove the cap
(Figure 3).
Figure 3
3. Bolts (2)
(Figure 4).
1. Snapper pin
Preparing the Cutting Units
1. Remove the cutting units from the cartons.
2. Assemble and adjust as described in the cutting
g004152
unit Operator's Manual.
3. Make sure that the counterweight
installed at the proper end of the cutting unit as
described in the cutting unit Operator's Manual.
1. Counterweight
10
Figure 4
2. Cap
(Figure
Figure 5
g003975
5) is
g003320