Table of Contents
Advertisement
1. Carriage bolt (3/8 x 1-1/4
inches)
2. Plate (rear carrier frame)
3. Spacer
2.
Align a spacer between the carrier plate
and mounting plate
assemble the plates and spacer with a carriage
bolt (3/8 x 1-1/4 inches) and flange locknut (3/8
inch).
Note:
If you are starting assembly at the back
of the cutting unit, use the middle holes of each
plate.
3.
Repeat step
2
at the other plate holes.
4.
Torque the flange locknuts to 37 to 45 N∙m (27
to 33 ft-lb).
7
Installing the Cutting Units
No Parts Required
Procedure
1.
Slide a thrust washer onto each front lift arm
pivot rod.
2.
Slide the cutting unit carrier frame onto the pivot
rod and secure it with a lynch pin
Note:
On rear cutting unit, position the thrust
washer between the rear of the carrier frame
and the lynch pin.
Figure 18
4. Mounting plate (cutting
unit)
5. Flange locknut (3/8 inch)
(Figure
14), and loosely
(Figure
1. Thrust washer
2. Carrier frame
3.
Grease all the lift arm and carrier frame pivot
g353096
points.
Important:
of twists or sharp bends and that the rear
cutting unit hoses are routed as show in
(Figure
shift them to the left (Model 03171). The
rear cutting unit hoses must not contact
the traction cable bracket. Reposition the
fittings and/or hoses if necessary.
4.
Route a tipper chain up through the slot on the
end of each carrier frame. Secure the tipper
chain to the top of the carrier frame with a bolt, a
washer, and a locknut
19).
19
Figure 19
3. Lynch pin
Ensure that the hoses are free
20). Raise the cutting units and
Figure 20
(Figure
g012016
g011965
21).
Advertisement
Table of Contents
