Getac 9270D Service Manual page 120

4.14 Miscellaneous Signals
Name
INTVRMEN
SPKR
RTCRST#
SRTCRST#
Type
Internal Voltage Regulator Enable: This signal enables the
I internal 1.05 V regulators.
This signal must be always pulled-up to VccRTC.
Speaker: The SPKR signal is the output of counter 2 and is
internally "ANDed" with Port 61h bit 1 to provide Speaker Data
Enable. This signal drives an external speaker driver device,
which in turn drives the system speaker. Upon PLTRST#, its
O
output state is 0.
NOTE: SPKR is sampled as a functional strap. See Section 4.30
for more details. There is a weak integrated pull-down resistor on
SPKR pin.
RTC Reset: When asserted, this signal resets register bits in the
RTC well.
NOTES:
1. Unless CMOS is being cleared (only to be done in the G3
I
power state), the RTCRST# input must always be high when all
other RTC power planes are on.
2. In the case where the RTC battery is dead or missing on the
platform, the RTCRST# pin must rise before the RSMRST# pin.
Secondary RTC Reset: This signal resets the manageability
register bits in the RTC well when the RTC battery is removed.
NOTES:
1. The SRTCRST# input must always be high when all other
I
RTC power planes are on.
2. In the case where the RTC battery is dead or missing on the
platform, the SRTCRST# pin must rise before the RSMRST#
pin.
Description