Installing The Dram Simm; B-4 Removing The Existing Dram Simm - Enterasys Matrix 7H4284-49 Hardware Installation Manual

Figure B-4 Removing the Existing DRAM SIMM
1 Connector arms
Installing the DRAM SIMM on 7H4284-49
Caution: Observe all antistatic precautions when handling sensitive electronic
equipment.
Precaución: Al trabajar con equipos electrónicos sensibles, tome todas las
precauciones de seguridad para evitar descargas de electricidad estática.
To install the memory module, refer to
1. With the connector arms set in the open position, insert the memory module between the
connector fingers and push the memory module into the connector until the tabs on the two
connector arms pull in towards the DRAM SIMM alignment notches.
2. Push the DRAM SIMM further into the connector until the two alignment notches and the tabs
on the two connector arms lock the DRAM SIMM into place.
Memory Locations and Replacement Procedures
À
Â
2 Memory module
Figure B-5
Mode Switch Bank Settings and Optional Installations
Á
À
3 Connector
and proceed as follows:
B-7