Installing The Dram Simm - Enterasys Matrix DFE-Gold 4G4202-60 Hardware Installation Manual

Installing the DRAM SIMM on 4G4202-60 or 4G4282-41
Caution: Observe all Electrostatic Discharge (ESD) precautions when handling sensitive
electronic equipment.
Precaución: Al trabajar con equipos electrónicos sensibles, tome todas las precauciones
de seguridad para evitar descargas de electricidad estática.
To install a DRAM SIMM, refer to Figure
1. Push the connector arms away from the DRAM SIMM enough to insert the DRAM
SIMM into the connector contacts.
2. Insert the DRAM SIMM straight down between the connector contacts enough for the
tabs on the connector arms to align with the two DRAM SIMM alignment notches.
3. Push the DRAM SIMM down into the connector contacts. Then rotate the two
connector arms toward the DRAM SIMM to lock it into place.
Figure B-5 Installing the DRAM SIMM on 4G4202-60
➀
Connector arms
➁
DRAM SIMM
B‐5 and proceed as follows:
Ã
Á
À
Â
➂
Connector contacts
➃
Alignment notches (2)
Matrix DFE-Gold Series Modules Hardware Installation Guide B-9
Memory Locations and Replacement Procedures
4G4282-41
or
Ã
À