About This Guide; Important Notice; Who Should Use This Guide - Enterasys Matrix 7H4284-49 Hardware Installation Manual

Dfe-platinum series

Hide thumbs Also See for Matrix 7H4284-49:

Table of Contents

This guide provides an overview, installation and troubleshooting instructions, and specifications

for the Enterasys Matrix

For information about the CLI (Command Line Interface) set of commands used to configure and

manage the DFE modules, refer to the Enterasys Matrix DFE-Platinum Series Configuration

Guide.

Note: In this guide, the following terms are used:

•

DFE refers to Distributed Forwarding Engine series of modules.

•

DFE module or module refers to the 7H4284-49 unless noted differently.

•

Network expansion module or NEM refers to an optional uplink card installed on the

main logic board and accessible through the option slot of the 7H4284-49.

Depending on the firmware version used in the DFE module, some features described in this

document may not be supported. Refer to the Release Notes shipped with the DFE module to

determine which features are supported.

Electrical Hazard: Only qualified personnel should perform installation procedures.

Riesgo Electrico: Solamente personal calificado debe realizar procedimientos de

instalacion.

Elektrischer Gefahrenhinweis: Installationen sollten nur durch ausgebildetes und

qualifiziertes Personal vorgenommen werden.

This guide is intended for a network administrator responsible for installing and setting up the

DFE module.

7H4284-49 DFE-Platinum module.

About This Guide

Table of Contents