How To Use This Guide; Related Documents - Enterasys Matrix 7H4284-49 Hardware Installation Manual

How to Use This Guide

HOW TO USE THIS GUIDE
This preface provides an overview of this guide and the DFE module Series manual set, and a brief
summary of each chapter; defines the conventions used in this document; and instructs how to
obtain technical support from Enterasys Networks. To locate information about various subjects in
this guide, refer to the following table:
For...
An overview of the DFE module
Network requirements that must be met
before installing the DFE module
Instructions to install the DFE module
hardware
Troubleshooting installation problems and
diagnosing network/operational problems
using the LANVIEW LEDs
Specifications, environmental requirements,
and physical properties of the DFE module
Instructions to set the mode switches when
necessary and remove and replace DRAM
SIMM and DIMM memory

RELATED DOCUMENTS

The manuals listed below can be obtained from the World Wide Web in Adobe Acrobat Portable
Document Format (PDF) at the following site:
http://www.enterasys.com/support/manuals
•
Enterasys Matrix DFE-Platinum Series Configuration Guide provides information on how to
use the Command Line Interface to set up and manage the DFE modules.
•
Cabling Guide provides information on dB loss and cable specifications.
Unlike the Enterasys Matrix DFE-Platinum Series Configuration Guide, the Cabling Guide is
not listed alphabetically on the web site. Instead, it is listed under the Overview Guides link.
xvi About This Guide
Refer to...
Chapter 1, Introduction
Chapter 2, Network Requirements
Chapter 3, Installation
Chapter 4, Troubleshooting
Appendix A, Specifications
Appendix B, Mode Switch Bank Settings and
Optional Installations