Dram Simm Connector Location; Installing The Dram Simm - Enterasys 2G4072-52 Installation Manual

Memory Locations and Replacement Procedures
3. Push the connector arms away from the memory module to release the DRAM SIMM
from the connector, as shown in Figure
Figure B-6
1 Connector arms

Installing the DRAM SIMM

To install the memory module, refer to Figure
1. Push the connector arms away from the DRAM SIMM far enough to insert the DRAM
SIMM into the connector contacts.
2. Insert the DRAM SIMM straight down between the connector contacts far enough for
the tabs on the connector arms to align with the two DRAM SIMM alignment notches.
3. Push the DRAM SIMM down into the connector contacts. Then rotate the two
connector arms toward the DRAM SIMM to lock it into place.
B-8 Mode Switch Bank Settings and Optional Installations
Note: The ejector arms on this connector are not spring loaded, so they will remain in the
open position until manually closed.

DRAM SIMM Connector Location

À
2 DRAM SIMM
B‐6.
Á
Â
À
3 Connector contacts
B‐7 and proceed as follows: