B-3 Nem Removal And Dram Simm Connector Location On The 7H4284-49 - Enterasys Matrix 7H4284-49 Hardware Installation Manual

Memory Locations and Replacement Procedures
Figure B-3 NEM Removal and DRAM SIMM Connector Location on the 7H4284-49
1 NEM (not on all DFE modules)
2 Main PC board
3 Screws
2. Refer to Figure B-4. Push the connector arms away from the memory module to release it from
the connector.
Note: The ejector arms on this connector are not spring loaded, so they will remain in
the open position until manually closed.
3. Remove the module from the connector.
B-6 Mode Switch Bank Settings and Optional Installations
Â
Ã
4 DFE module front panel
5 Module connectors on main board
6 DRAM SIMM memory module
Ä
Á
À
Å