Last Resort Shutdown Procedure Using Offline/Reset Button - Enterasys Matrix 7H4284-49 Hardware Installation Manual

4.3.2 Last Resort Shutdown Procedure Using
OFFLINE/RESET Button
Caution: This method of shutting down a DFE module is not recommended except as a
last resort, because all processes currently running on the module will be interrupted
resulting in loss of frames.
Precaución: No se recomienda utilizar este método para apagar los módulos DFE.
Recurra a él sólo como último recurso, puesto que interrumpe todos los procesos del
módulo en funcionamiento, lo que podría resultar pérdidas de frames.
To reset a DFE module without it performing an orderly shutdown routine,
press and hold the OFFLINE/RESET button for approximately 6 seconds.
Pulling any DFE module out of the chassis before it has been shut down is not recommended. The
only safe time to pull a module out of the chassis is after the completion of a shutdown and the
management LED is flashing amber/off.
Overview of DFE Module Shutdown Procedure
Troubleshooting 4-9