3. Push the release tabs
simultaneously lift the DRAM SIMM enough to release it from the connector
4. Rotate the DRAM SIMM
connector .
Figure B-4 Removing the Existing DRAM SIMM
À
Release Tabs
B.4.3
Installing the DRAM SIMM
CAUTION: Observe all antistatic precautions when handling sensitive electronic
equipment.
To install a DRAM SIMM, refer to
1. With the SIMM alignment notch
between the connector fingers
away from the DRAM SIMM
upwards as shown in
Á
DRAM SIMM
Figure B-5
oriented as shown in
.
Optional Installations and Mode Switch Bank Settings
, as shown in
Figure B-4
and remove it from the
Â
À
and proceed as follows:
Figure
SIMM Replacement Procedure
Figure B-4
and
.
Connector
B-5, insert the SIMM
down
B-7