Installing The Dram Simm - Enterasys Matrix 7H4385-49 Hardware Installation Manual

Installing the DRAM SIMM

Caution: Observe all Electrostatic Discharge (ESD) precautions when handling sensitive
electronic equipment.
Precaución: Al trabajar con equipos electrónicos sensibles, tome todas las precauciones
de seguridad para evitar descargas de electricidad estática.
To install the DRAM SIMM, refer to Figure
1. With the connector arms set in the open position, insert the DRAM SIMM between the
connector fingers and push the DRAM SIMM into the connector until the tabs on the
two connector arms pull in towards the alignment notches.
2. Push the DRAM SIMM further into the connector until the two DRAM SIMM
alignment notches and the tabs on the two connector arms lock the DRAM SIMM into
place.
3. Reinstall the network expansion module. Refer to "Installing the Network Expansion
Module (NEM)" on page B‐11 for instructions.
4. Reinstall the safety cover. Refer to "Reinstalling the Safety Cover" on page B‐13 for
instructions.
Figure B-6 Installing the DRAM SIMM
1 Connector arms
2 DRAM SIMM
B‐6 and proceed as follows:
Ã
À
Â
3 Connector fingers
4 Alignment notches (2)
DFE-Platinum Series Hardware Installation Guide B-9
Gaining Access to Memory Modules
Á
Ã
À